Multi-Pump Seneca Dragonfly MK2 On The Way

[PasadenaMike]

The Update on the gun is it’s constantly shifting POI as mentioned before . I tried it with and without scope and also with and without a moderator all with the same poi shift. The stock and barrel screws are all torqued to the breaking point and backed off 1/4 turn with my calibrated elbow. The design I believe is such that the pumping shifts the barrel and is unable to stay consistent. Life is too short to mess with this design (and tune fxs lol) it’s going back to pa as a defect.

 

[Hateful McNasty]

The Update on the gun is it’s constantly shifting POI. I tried it with and without scope and also with and without a moderator all with the same poi shift. The stock and barrel screws are all torqued to the breaking point and backed off 1/4 turn with my calibrated elbow. The design I believe is such that the pumping shifts the barrel and is unable to stay consistent. Life is too short to mess with this design (and tune fxs lol) it’s going back to pa as a defect.

Maybe just that 1 in 100,000 lemons I always tend to get ( too bad my lottery luck don't run as well ) .

You honestly don't see too many compliments on that gun around and most seem pretty satisfied ..

Anyway good luck on the rma

 

[PasadenaMike]

Maybe just that 1 in 100,000 lemons I always tend to get ( too bad my lottery luck don't run as well ) .

You honestly don't see too many compliments on that gun around and most seem pretty satisfied ..

Anyway good luck on the rma

Yeah I agree we must be a lemon farm lol because this happens a lot with low end stuff

 

[Hateful McNasty]

Yeah I agree we must be a lemon farm lol because this happens a lot with low end stuff

Well it everything for me . But the " higher end" just hurts my feelings More the the lower.. I guess it's that expectations factor.

I posted here somewhere on what looks like a gamo multi pumpte coming ..
(gamo vapor x10).

looks interesting

 

[pan60]

i am glad to stick with my benji's and dan's.

 

[PasadenaMike]

i am glad to stick with my benji's and dan's.

I was going to say something about the Ben’s. They have a solid build they basically can’t move poi. It just works just pumping is a you know what.

 

[pan60]

I was going to say something about the Ben’s. They have a solid build they basically can’t move poi. It just works just pumping is a you know what.

LOL
yea real since i got the PCP guns i dont think we have touched the pumpers at all.
i told Carol we should set up in the with and shoot down the hall way but our winter are just not that bad we might mis a few days here and there but we can shoot out the window from the sunroom if we want.
plus she vetoed shoot down the hall

 

[Danman]

The Update on the gun is it’s constantly shifting POI as mentioned before . I tried it with and without scope and also with and without a moderator all with the same poi shift. The stock and barrel screws are all torqued to the breaking point and backed off 1/4 turn with my calibrated elbow. The design I believe is such that the pumping shifts the barrel and is unable to stay consistent. Life is too short to mess with this design (and tune fxs lol) it’s going back to pa as a defect.

Hey Mike did u ever get it on the chrony? I know springers and pcps and they both (can) rule in the consistent fps department. I don't know pumpers well but I'd think if your getting bad spreads then poi would also be bad ?

 

[PasadenaMike]

Hey Mike did u ever get it on the chrony? I know springers and pcps and they both (can) rule in the consistent fps department. I don't know pumpers well but I'd think if your getting bad spreads then poi would also be bad ?

Actually yeah what I did was test 6-15 pumps and here are the velocities. I didn’t test for consistency but I didn’t want to keep messing with it my PCPs were giving me dirty looks recently and I just realized why.

 

[Hateful McNasty]

Actually yeah what I did was test 6-15 pumps and here are the velocities. I didn’t test for consistency but I didn’t want to keep messing with it my PCPs were giving me dirty looks recently and I just realized why.

I'd have to assume there's poi swings along with them fps swings.. so if you were to go consistent pumps/fps do you still get the poi wide changes ? I seen straight shots at constant 850 bit throw curves at 600 same gun same pellet for example.

 

[PasadenaMike]

I'd have to assume there's poi swings along with them fps swings.. so if you were to go consistent pumps/fps do you still get the poi wide changes ? I seen straight shots at constant 850 bit throw curves at 600 same gun same pellet for example.

I just chose 6 pumps at 750 ish and I would get 3 in the same hole then it’ll completely shift 4 inches low for example and start grouping there a few shots. I didn’t chronograph a string of the 6 pumps to check consistency but I don’t care to anymore

 

[Hateful McNasty]

I just chose 6 pumps at 750 ish and I would get 3 in the same hole then it’ll completely shift 4 inches low for example and start grouping there a few shots. I didn’t chronograph a string of the 6 pumps to check consistency but I don’t care to anymore

Well you'd got to assume if you use 6 pumps the first should be near the same or equal to as the last in fps in 6 pumps consistently..

Ya, just sounds like a rma gun now to me for sure ...

You'll know for sure if the replacement gun holds true or not ...

 

[PasadenaMike]

Well you'd got to assume if you use 6 pumps the first should be near the same or equal to as the last in fps in 6 pumps consistently..

Ya, just sounds like a rma gun now to me for sure ...

You'll know for sure if the replacement gun holds true or not ...

Oh it’s just a return I’m not getting another one. I’m going to play with my folding “survival” break barrel next that one is Dana approved

 

[Hateful McNasty]

Been there on one or two as well.. too sour of a taste left to exchange. Just move on to the next one ...

I wish them fishing ones were out back in my good ol days ... I could of popped some red horse suckers from the creek with one nicely ...

 

[PasadenaMike]

Pyramyd air is awesome!!!! Wow what a $h!t show with trying to send the gun back in the hands of UPS. Getting an RMA was easy. Shipping label was easy. Packing and shipping was easy. Gun lost in transit. Ummmmm what? Now what. Pyramyd Air stepped up and shined in a situation where UPS wouldn’t care about us peasants. The package is lost snd PA refunded the gun. That is customer service. Here take more $$$$$$ please thank you PA. I’m very picky about who I shop from and you’re 1/5 of shops I choose.

 

[Hateful McNasty]

They do me right if a issue or rma .. honestly can't complain. Now just ditch them popup things like spin the wheel . Times running out , ect.. lol.

 

[PasadenaMike]

They do me right if an issue or rma .. honestly can't complain. Now just ditch them popup things like spin the wheel . Times running out , ect.. lol.

lol that’s ok as long as they stand behind the sale they can pop up anything they want

 

[Hateful McNasty]

lol that’s ok as long as they stand behind the sale they can pop up anything they want

Sadly everything I look at is a "excluded from coupons". Anyway do they really need to make it so intrusive and hinder shopping ..? To me there pretty annoying. Then can't he used ..lol


( To right of circled thing for example)


You know I wonder if it got lost ( your rma package) or if it was the UPS "gun police" that confiscated , busted it up , and chunked in dumpster .. ?

 

[PasadenaMike]

Sadly everything I look at is a "excluded from coupons". Anyway do they really need to make it so intrusive and hinder shopping ..? To me there pretty annoying. Then can't he used ..lol


( To right of circled thing for example)
View attachment 4686

You know I wonder if it got lost ( your rma package) or if it was the UPS "gun police" that confiscated , busted it up , and chunked in dumpster .. ?

Or someone at UPS now has a defective Seneca Dragonfly that they cant hit anything with. They’ll join GTA asking how to fix a Seneca that can’t hit anything lol

 

[Hateful McNasty]

Or someone at UPS now has a defective Seneca Dragonfly that they cant hit anything with. They’ll join GTA asking how to fix a Seneca that can’t hit anything lol

LoL.. good one..