Panthera FX .30 Bull Barrels Are In Stock

[Billm]

Thanks good info. I could probably flute mine on my CNC machine, but I’m not going to chance ruining it. At some point I would think that we will see diminishing returns. I managed to miss falling into the rabbit hole, I was swallowed by it.

 

[Auto1191]

Thanks good info. I could probably flute mine on my CNC machine, but I’m not going to chance ruining it. At some point I would think that we will see diminishing returns. I managed to miss falling into the rabbit hole, I was swallowed by it.

If I were you, I would hold tight, It seems your on the right path, but then again, I am still waiting giving my input. I brought myself to the conclusion I will probably have to wait till the end of AUGUST or SEPTEMBER or IWA, to start all over, AGAIN LOL By the way if you don.t mind me asking what happened to your rifle

 

[Billm]

If I were you, I would hold tight, It seems your on the right path, but then again, I am still waiting giving my input. I brought myself to the conclusion I will probably have to wait till the end of AUGUST or SEPTEMBER or IWA, to start all over, AGAIN LOL By the way if you don.t mind me asking what happened to your rifle

It has jammed the magazine on at least three different times. The first couple of times, I was able to unjam it by sliding the shank of an X-Acto blade in between the magazine cover and rotating the mag. Then there’s usually a pellet slug partially chambered that I can usually push out.
I was shooting and the velocity suddenly dropped and the magazine jammed.
This time the mag carrier would rotate, but I still couldn’t remove the magazine. I had to slice the pellet in half with the X-Acto blade and then rotate the mag to remove it. Then I found it had double stacked. I removed the other pellet and then I test fired it. The velocity was low and there was a blast coming from the breech. I replaced the breech o-rings and reassembled it. I test fired it again and had less of a drop and still had air coming from under and around the mag.. I fired it a second time and the heard the air escaping out of the barrel. I cocked it and that didn’t help and so I removed the Arca Rail and barricade stop and found the valve stem extended and stuck forward. I pushed then pin in and was able to gas it up. I disassembled it again and replaced the barrel o-rings in the block. Reassembled it and test fired again - no change. I’m assuming that valve stem o-ring and or valve stem are bad. I don’t mind sharing my tribulations, if it might help someone else.