My preparations for the World Air Rifle Benchrest Championship are well underway!
I’ll be competing alongside Barbara Pellegrino and we will be using the follow equipment for the matches:
Light Varmint: 12fpe Daystate Revere in a Custom benchrest stock
Heavy Varmint: BRK Ghost .177 Carbine in Red with wide paddle type rest that sits very snug in the Nota rest.
50m Unlimited: Daystate Red Wolf .22 in a Custom PRS Red Chassis
All of them will be topped with the Kahles k1050i which we will switch from gun to gun.
The event is being held in Pilsen in the Czech Republic. More information can be found on www.wcpilsen.com
One thing that was absolutely necessary was to cut new foam for my cases. I am taking multiple guns which I never do and had to reorganize EVERYTHING!
How do you cut foam? Or Do you even cut foam?
I’d love to hear everyone’s opinions!
I’ll be competing alongside Barbara Pellegrino and we will be using the follow equipment for the matches:
Light Varmint: 12fpe Daystate Revere in a Custom benchrest stock
Heavy Varmint: BRK Ghost .177 Carbine in Red with wide paddle type rest that sits very snug in the Nota rest.
50m Unlimited: Daystate Red Wolf .22 in a Custom PRS Red Chassis
All of them will be topped with the Kahles k1050i which we will switch from gun to gun.
The event is being held in Pilsen in the Czech Republic. More information can be found on www.wcpilsen.com
One thing that was absolutely necessary was to cut new foam for my cases. I am taking multiple guns which I never do and had to reorganize EVERYTHING!
How do you cut foam? Or Do you even cut foam?
I’d love to hear everyone’s opinions!
As far as foam goes, they sell hot wire cutters at craft stores... beyond that I've only ever used a razor blade.
razor blades, hot wire, even cookie cutters work for the tins of your preferred projectile.*make your cutouts a couple of MM inside of your tracing, then the foam will snug against your gear*
