PCP thumper repair

[old navy]

i have got to figure out how to use the site sorry trying to fix a thumper i got free because it didnt work i later got a stryker that continues to surprise me with its accuracy trying different pellets and it likes a lot but i would like to make the thumper my learning experience. for any help i would be grateful i am bad with computers so bear with me ty

 

[old navy]

finally got the Thumper fixed, the brass face the poppet valve seats against was not flat.
Now that it is working I want to set it up as a night pesting gun, there in lies in my question.
My night vision has a pic. rail attached, but it wont fit on the rounded rail on the Thumper.
Has anyone tried the UTG dovetail to Pic. riser or will it ride high in the rounded bottom also????
hope someone found a solutions

 

[hameditor]

finally got the Thumper fixed, the brass face the poppet valve seats against was not flat.
Now that it is working I want to set it up as a night pesting gun, there in lies in my question.
My night vision has a pic. rail attached, but it wont fit on the rounded rail on the Thumper.
Has anyone tried the UTG dovetail to Pic. riser or will it ride high in the rounded bottom also????
hope someone found a solutions

Hopefully @Pinty Official can help with the answer to this...

 

[PapaT]

finally got the Thumper fixed, the brass face the poppet valve seats against was not flat.
Now that it is working I want to set it up as a night pesting gun, there in lies in my question.
My night vision has a pic. rail attached, but it wont fit on the rounded rail on the Thumper.
Has anyone tried the UTG dovetail to Pic. riser or will it ride high in the rounded bottom also????
hope someone found a solutions

If this is an original (Gen 1) Thumper then the pic rails were sized too skinny and so replacement rails were offered (although original screws are too short to reuse and properly bite).

Either way a dovetail to pic adapter won't work because dovetail is for 11mm vice 20-22mm that the pic rail may be in width. There are picatinny to picatinny risers that you could try, although this direction will make everything sit high on the gun. Hope this helps some.

 

[old navy]

I have the 20-got 1 of the first after the correction
I think some of the pic risers are rounded on the bottom so it may be affected by bad pic. rail on gun

 

[old navy]

may not be affected

 

[Madhatter]

but I did not shoot the deputy...

 

[FL22]

but I did not shoot the deputy...

Is this your way of saying you got that squirrel just randomly dropping it in a thread somewhere?

 

[Madhatter]

No, it's a play on I shot the sheriff. I still haven't been able to get that dang squirrel yet.