Centerfire
HAM Specialist
After 4 years of use on 480cc bottles and 186cc tubes (183fills, 2-3 minute each) I had an air leak to find. The usual suspects of the o-ring in the coupler or a loose fittting were all checked and ok.
What I found was the Filter Body #125 where the Bleed screw screws into the #130 Exhaust nut needed to be removed, cleaned, and inspected.
I found that the #129 exhaust valve gasket (black plastic plug with a hole in it ) was not shutting off the air.
Waiting for vendor advice on parts but wnted to know if anyone else has had this problem? Are parts available? O-Ring and ball bearing not shown on drawing.
Centerfire
What I found was the Filter Body #125 where the Bleed screw screws into the #130 Exhaust nut needed to be removed, cleaned, and inspected.
I found that the #129 exhaust valve gasket (black plastic plug with a hole in it ) was not shutting off the air.
Waiting for vendor advice on parts but wnted to know if anyone else has had this problem? Are parts available? O-Ring and ball bearing not shown on drawing.
Centerfire