Alpha/Delta Wolf Factory .22cal tables

[Corvid_Hunter]

I took screen shots of the factory tables for my .22cal Delta Wolf. The 25gr table seems to have low working pressure compared to the others. This was with the latest firmware installed. I'm not sure how the rifle shoots as it's still in the shop.

 

[Danman]

I took screen shots of the factory tables for my .22cal Delta Wolf. The 25gr table seems to have low working pressure compared to the others. This was with the latest firmware installed. I'm not sure how the rifle shoots as it's still in the shop.

View attachment 16397

View attachment 16398

View attachment 16399

View attachment 16400

View attachment 16401

Well for some reference (mechanical vs electronic i know) my ghost with same barrel will send the Mrds 975fps with 150Bar set on 15, so id say its not to far off.
195Bar for the 33gr beasts....yikes that sounds painful!!

 

[Corvid_Hunter]

Well for some reference (mechanical vs electronic i know) my ghost with same barrel will send the Mrds 975fps with 150Bar set on 15, so id say its not to far off.
195Bar for the 33gr beasts....yikes that sounds painful!!

High reg pressures wig me out for some reason.

 

[Linehauler73]

I have found both my guns perform at much lower reg pressure than recommended. I have also found that the guns aren’t voodu magic either. You still need to do your part setting a realistic reg pressure for what you want to do. For example with my .25 (non ultra valve I believe) I will run 140-150 bar to shoot 33.95 880-900. At that pressure it will tune itself in factory or I can tune it down in advanced to shoot 25.39 at the same speed. The gun will do it but not nearly as well if I set the reg lower to shoot lighter pellets. At the higher reg if the gun sits for a period the first shot or two will be quite a bit lower speed for the 25.39. Bump the reg down to like 120-125 and the 25.39 perform flawlessly like the 33.95 do at 150 bar. At 125 bar I can only get about 840’s with 33.95. Setting reg pressure to projectile weight helps a lot in my experience . Currently it’s 125 bar and I shoot 25 and 29 gr out of it.
I saw a video recently of one that must have had an ultra valve. His would shoot 33.95 up around 900 at 125 bar. Pretty impressive. Just some things for thought. You will have to play around with it. Just note the recommended pressures are not always best in my experience. Just takes some time getting used too.

Also, I have found in factory mode sometimes it tunes to your input speed quite quickly…like a cpl shots and sometimes for whatever reason it may take 6-10.

 

[Corvid_Hunter]

Thanks. I appreciate it.