AtlasAirguns
Good Plus Level Advertiser
Usually the instruction manual is tucked discretely inside one of the Savior case pockets, but if not all instructions are on www.westernairguns.comI’d intended to do some shooting on Sunday, but someone was hosting an event. I could hear them so they would’ve heard me shooting if I got started and I didn’t want to frighten any guests if they’re city folks bit accustomed to hearing gunshots as a part of healthy everyday living.
I did mount a Sightron STAC atop my Rattler .45 Ling Strike. I don’t think I’ll leave it on there. I have to look through some more scopes. I was thinking of putting a 4-16x on there. I definitely want a FFP scope on it. I have several scopes mounted and have to determine if I want to swap them around. For not eh Sightron will do. I have to wrap the parallax knob with white tape so I can setup my scope tape marking since Sightron STACs lack numbers on the parallax knobs. It’s in some low Butris Signature rings. I placed a piece a blue painters tape on the bottom of the objective need to prevent the finish from being scratched by vibrations from the shots. You can also see the section of arcs plate that I attached to the pic rail in order to mount the rifle to a tripod.
View attachment 23717
I also noticed that the shroud is in 2 sections. I tried unscrewing it and noticed a small scratch in the shroud above the band that helps to brace the bottle reservoir. I don’t know if it scratched it or if it came that way. I also placed a piece of blue tape on the shroud here was well. They are too close together for my taste. It’s to the point where the shroud can become damaged. I may wrap this section of the shroud with camp tape later.
View attachment 23716
Because it’s gotten cooler, I wanted to cover the cheek piece which is a non-adjustable piece of hard plastic screwed down onto the reciever. I covered it with a thin, but soft neoprene strip with and adhesive backing. I cut it as I situated it on the cheek piece. It is noticeably more confortable.
View attachment 23714
It appears that my ref has been set to 195 bar from AOA. The rifle says “Max Pressure 300 bar.”
View attachment 23718
I’m not too keen on filling Rattlers above 250 bar due to my experience with my .357 Rattler experiencing reg creep with higher fill pressure. I need to contact someone at AOA about this to be sure. My rifle didn’t come with an instruction manual or leaflet. After topping the rifle off I was happy to see that the reg set point didn’t move.
View attachment 23720
View attachment 23719
I had intended to shoot both untethered and tethered.