Others target plans how to?

[pan60]

Like i said 3/16 has been holding up too. Just buy a few however many you want gamo targets make the faceplate and don’t forget the paddle and i ran a bead right where the paddle twists to reinforce it. Put the 3/16 out farther is all. Oh hold your discs up 1/8” from bottom of paddle disc for clearance

if i have 3/16 in the shop that is what i will use for use just thinking if i have to buy metal i might go 1/4?
so this type pf target is the field target type?
what is the one made simular to what i have that has the holes?
is that also for firld target shoting or someother sport?

 

[Solo1]

if i have 3/16 in the shop that is what i will use for use just thinking if i have to buy metal i might go 1/4?
so this type pf target is the field target type?
what is the one made simular to what i have that has the holes?
is that also for firld target shoting or someother sport?

The 1 you have is for the speed shooting events they put out 5 rows of them and see who can knock them down the fastest but that event is for 177 cal only. Field targets are what the gamo are but for 177 again under 20 fpe. Buy adding the heavier face plate and paddle they will hold up to higher power. To my knowledge there are no other targets with holes except shoot to reset and their for 177

 

[Solo1]

Remington Shoot-To-Reset Airgun Target | Crow Silhouette

Enjoy target airgun shooting with no interruptions with this shoot-to-reset crow silhouette target from Remington

www.bakerairguns.com

 

[pan60]

i would like my better ( and i dont dislike it ) if the targets did not bounce back up and it was heveryer and i will most likely make a few. if they where heaver i dont think they would pop back in place when i shoot them.
but i want some of the Field targets like you have there and hey look simple enough.

 

[isledweller]

Here's a couple video links for you to look at...

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[pan60]

well doing my home work i just have to decide to make-em mod-em or buy-em
i was thinking about calling Dave at Rx targets i see he is making some of those speed ones out of the 1/4" and a design that stops the bounce back up.
i guess i sould probly send the wife to the casino that would make life easier if she wins?
thanks guys!