Others Crosman Mark II and SSP 250

[Kragman1]

Hi all

I bought a Mark II in .177 yesterday, in great shape and holding CO2 for at least a month that I know of.
I also bought an SSP 250 marked .177 but with a .22 barrel and loading gate installed.
Unfortunately, that one immediately emptied a CO2 cylinder when I pierced it during installation.

I know very little about either, so I'm hoping to get a discussion going here.

Thanks!

 

[Hateful McNasty]

Maybe reseal it and hope it works out .

Look around on who's got what for it still available.

Crosman SSP-250 Rebuild Kit

SSP 250 : JG Airguns, LLC

JG Airguns : SSP 250 - Accessories, Cleaning Supplies Airguns Ammo, Collectable Ammo, Shootable Books, Catalogs, Manuals, etc. CO2 Cylinders Collectables Mounts, Scopes, Sights, etc. Parts Tools Gift Certificates Buglespanner see Will JG Airguns Accessories, Cleaning Supplies Airguns Ammo...

www.jgairguns.biz

 

[Kragman1]

Thank you HMN

I found the kit for it last night, and also read that I may be able to straighten it out by adjusting the seal for the powerlet, via screw.

Also bought an Ampell CO2 that looks like a Thompson Center Contender. Looks like NIB, with all the paperwork, etc. I haven't tried a CO2 in it yet.

 

[Hateful McNasty]

My 38c crosman CO2 its the prick pin and it's seal . There's a updated Pearce pin for it but I not ordered a new seal kit for it .. ( I just don't do co2 anymore ) but I better get off my butt and do it before I can't .. them 38c&t pistols were pretty nice . ( Well most crosmans back then were good guns )