FL22
Grand HAMster
So Iām headed down the path of not caring about warranties anymore.
Started with trying to polish my barrel, which still hasnāt panned out yet.
I found two broken Orings lots of loose screws and with a Dremel bit performed some light deburring by hand (on the brass seal carrier air inlet port).
My owners manual and the downloadable version online doesnāt even show the Oring (#56 is for sealing the pellet probe), however other model S510s show it.
Might explain why it seemed to be getting louder to me and a loss of accuracy.
There was an excess of glue/thread locker between the carrier and the barrel where the Oring is seated, I carefully and thoroughly cleaned it.
I found some O-rings on Amazon and some bore mops. The one I had even though it was a .22 wouldnāt fit.




Started with trying to polish my barrel, which still hasnāt panned out yet.
I found two broken Orings lots of loose screws and with a Dremel bit performed some light deburring by hand (on the brass seal carrier air inlet port).
My owners manual and the downloadable version online doesnāt even show the Oring (#56 is for sealing the pellet probe), however other model S510s show it.
Might explain why it seemed to be getting louder to me and a loss of accuracy.
There was an excess of glue/thread locker between the carrier and the barrel where the Oring is seated, I carefully and thoroughly cleaned it.
I found some O-rings on Amazon and some bore mops. The one I had even though it was a .22 wouldnāt fit.








