What'cha doing air gun related today?

[Madhatter]

I suppose the best answer I can come up with is..., I get bored and need to 'tinker' with stuff to keep my mind active.

Idle hands are the work shop of the devil .

 

[Murfdurf82]

Idle hands are bad thing for knuckleheads like myself well a younger version of myself. Swapped (temporary, just to try different guns) my Notos with my friends aea HP SS .25, so for I've had to respool a magazine and found the rifle prefers some jts 25.39s. and about 20 shots with fps range from 785-725 before it dropped off my target and 25 yards. It's super quiet with my whisper GL. It's a fun pistol/carbine with the folding stock and semi auto action. I'll see might have time to finish taking apart my Nova Liberty and see why it's locked up. It's time to do Sundays home work so maybe later today.

 

[Madhatter]

Locked up?? Let me know what you are talking about. I've probably dealt with every problem the liberty can come up with.

 

[Playingdead]

Worked on the range today. I needed a way I make a target higher and still add new targets.

Learned about this from @RIP. Used a bracket on a T-Post. I can raise and lower it to work on it. It is way higher than I can reach now.

 

[Murfdurf82]

Locked up?? Let me know what you are talking about. I've probably dealt with every problem the liberty can come up with.

When I shoot it takes a couple of cock and shots to get the pellet to come out of the barrel. It's just a "spurt" of air not the entire burst of air every time I cock and pull the trigger. I have plenty of air in the tank. When I degassed I had to shoot probably 12-15 times for the air in the regulated area to empty it out of air so I could adjust the regulator. It's like the valve pin doesn't move much when the trigger is pulled. I haven't taken the hammer spring out yet, to make sure everything is ok in there.

 

[Madhatter]

Can you take the hammer spring out? If you can check to make sure the hammer moves freely. Until I put a couple of Orings between the hammer face and the valve the ridge that it would slam into the hammer bore and cause it the deform and grip the hammer so tight the hammer wouldn't open the valve right.

 

[Murfdurf82]

Can you take the hammer spring out? If you can check to make sure the hammer moves freely. Until I put a couple of Orings between the hammer face and the valve the ridge that it would slam into the hammer bore and cause it the deform and grip the hammer so tight the hammer wouldn't open the valve rig

Yes I have the stock off so I can check the hammer spring. I'll let you know what I come up with.