PCP Reximex rp review hunt

[MountainSportAirguns]

Here is a video of my experience using the Reximex rp in .22 caliber over several weeks. I took the gun out to the range, did some shooting and showed some of the features of this small pistol carbine. This is a great, low powered regulated PCP that worked really well for some of the ratting we did. Was even able to get out for a short Cottontail hunt. Hope some might find the video informative and entertaining.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[AtlasAirguns]

Absolutely phenomenal video. I hope to see more Reximex/PA collaborations with your channel in the future

 

[guidodg]

started off with a leak … but sorted it out

it was shooting at around 7.5ft\lbs and adjusting the hammer spring and regulator did very little …. so I fitted a heavier hammer spring and now it is sitting at around 11.8 ft\lbs

quite a barker but very accurate with JTS 16 gr Dead Centres and JSB 15.89

trigger was awful but with some tinkering it has improved…. but will change the springs soon to make it better

now to find a smaller scope and a different mounting arrangement… it does not like independent adjustable mounts since bizarrely the rear rail is 1.5 mm lower than the front and is not properly aligned either… so I will need another front mount extending backwards

 

[hameditor]

started off with a leak … but sorted it out

it was shooting at around 7.5ft\lbs and adjusting the hammer spring and regulator did very little …. so I fitted a heavier hammer spring and now it is sitting at around 11.8 ft\lbs

quite a barker but very accurate with JTS 16 gr Dead Centres and JSB 15.89

trigger was awful but with some tinkering it has improved…. but will change the springs soon to make it better

now to find a smaller scope and a different mounting arrangement… it does not like independent adjustable mounts since bizarrely the rear rail is 1.5 mm lower than the front and is not properly aligned either… so I will need another front mount extending backwards

Thanks for sharing!