I was in the process of doing the bottle conversion and hit a big snag. I cannot remove the air tube. It is like it is welded on.
In the process of removing it the tube body came off but left the actual valve on the gun. Am I doing something wrong? Now everything
I do to remove it, causes the tube to turn but leaves the valve attached. Is it a Lefty turn to loosen it? As is I have run out of ideas.
Additional info, the tube was degassed at last try. Should it be filled? I am concerned that if this thing is aired and it turns the tube body
and not the tube and valve, I will blow myself up. Any ideas or suggestions would be really appreciated. I just did a conversion on a Notos
and it all went fine.
In the process of removing it the tube body came off but left the actual valve on the gun. Am I doing something wrong? Now everything
I do to remove it, causes the tube to turn but leaves the valve attached. Is it a Lefty turn to loosen it? As is I have run out of ideas.
Additional info, the tube was degassed at last try. Should it be filled? I am concerned that if this thing is aired and it turns the tube body
and not the tube and valve, I will blow myself up. Any ideas or suggestions would be really appreciated. I just did a conversion on a Notos
and it all went fine.
