Search results

First thanks to "Franklink" for all of the guidance and support! I eventually used a 3/8" OD x 1/8" Nylon Spacer (Ace Hardware), and had to sand it's "length" down to 0.1220" (3.10 mm) to get the lighter pellets under 900 ft/s with the PW at Min. The shim/spacer goes in between the hammer and...

Read a bunch of different posting, then I pulled the barrel, clamped it in a vice (with rubber pads), J-B Bore Cleaning with *Brass brush (it turned black), followed by patches with Hoppe's Bore Cleaner, then cotton mop with Hoppes, then Fritz Paste Polish for Metals with cotton mop till it...

.177, HP Barrel-23", LP Spring, no problem dialing it in sub 20 ft-lb. Right now I am going back and forth between the JSB heavies and the H&N Barcuda Match to see which ones size with the least number of "rejects" and cocurrently which ones hold the tightest group for my barrel.

Hello Solo1, where can I get a scope wheel like that for my Element Helix 6-24-50? thanks, tc

Oldest has black hair, middle has blonde, and the third....he is a ginger! I wanted to have one more just to see what color hair he/she would have...

I think this is due to the regulator creeping when idle...I have the Sekhmet on my Regulator, set for 2900 psi (200 bar) and it will creep up to 2980 ish after several hours of non use....and to your observation the first shot or two is lower velocity for the same Power Wheel setting, but then...

I haven't counted yet, as I am still learning about the rifle's *performance and still trying to (I haven't had a lot of time since getting the rifle): 1. Find the optimal velocity for my barrel and pellet(s) (precision) 2. Find the settings that gives the lowest spread and std deviation on...

The first fill will make you warm for sure, I believe I stopped ~3/4 of the way on that first fill because the pump was dumb hot too...I don't let the bottle pressure get below 200 bar before pumping. Only takes a couple min to get it back to 250. Yes the OEM bottle gauge in my opinion is not...

Looking at the parts diagram, I was thinking that the washer would go in before the hammer spring, as it appears that that surface is flat and thus the hammer spring would hold it in place. Also the M5 nylon washer appears to be just the right diameter ...and I found this ....I will keep you...

My set up: 177 HP, FX V2 mounted left side picatinny, Wika black face 0-250 bar bottle gauge (the stock gauge is lame in my opinion, too small of a scale, normal fill pressure in RED, and it underread the pressure by 25+ bar), Sekhmet Digital Reg gauge (for the ability to read more accurately...

Found this: https://hardairmagazine.com/reviews/labradar-tips-and-tricks-for-airgun-use/ where they state that alloy pellets wouldn't track on the Labrador Doppler Radar...the Greens are a tin alloy.

I find that my V2 mounted on the Ghost's left side picatinny rail...It captures 99+% of my shots...EXCEPT it will not capture any of the 177 H&N Field Target Trophy Green pellets...still not sure why...

Hello Team Daystate, With 5 different Hammer Springs available, 3 barrel lengths and an adjustable regulator...what were/are the designer's expectation for Barrel length, regulator Set Point vs Hammerspring vs caliber-wt? Is there an optimal set point range of the regulator that gives the...

My first couple depressurizings via dry firing did not result in a jammed cocking lever. But I also found that by adjusting the Regulator to max pressure prior to disconnecting the bottle the gun will vent out the bottle connection, and that is how I depressure my rifle now.