Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thanks for the great information!Heya this will be my second Barra 250z in 22 rifle. First had to RMA due to ar grip hardware being completely separated from the rifle chassis from factory. The replacement came Friday. Saturday I installed the gear - bipod, 4-16x50 monstrum mrad scope and gave her a good cleaning. Today I chronographed and tuned. So far using 25gr Apolo Slugs, here's my current settings and break down.
Current Setup
2,000 PSI Reg
Hammer spring backed out 100%
Hammer Spring set 3.5 Turns In.
1. Power Output
Muzzle Velocity (FPS): ~825-837 FPS
Muzzle Energy (FPE): ~38.1-38.9 FPE
This is a significant increase from the factory default setup (~25 FPE). A gaine of about 13+ FPE at the muzzle, meaning slugs should retain much more energy at 100 yards.
2. Consistency & Spread
Extreme Spread (ES): ~10-14 FPS
Standard Deviation (SD): ~3.5-5.5 FPS
The regulator and hammer setup appear to be working well together. These are very tight numbers, which is good!
FPE at distance
Currently maintaining over 25+ FPE past 30 yards and still carrying 13+ FPE at 100 yards, which target dependant, means lights out.
Estimated shots per fill 30-35 good shots before dropping off a little bit, had 4 mags loaded.
Good numbers alone are just part of it. How is your actual accuracy at 100y? I honestly did not try to run a slug that slow, so I am very curious. When I was shooting 25gr H&N .218 with the reg at 2300psi I was getting 909fps 45.8fpe. That's the slowest speed that I have shot and I use about 50psi per shot, basically the same shot count as you but with more power. The slug with it's increased surface area takes more power faster to get moving and stay efficient. If you want to shoot slugs, especially ones over 21gr, you should turn up your reg. If you want to be effecient with pellets +/- 2000psi is fine because it is significantly easier to get them going. Whatever reg pressure you use just has to be balanced out btween the friction of a slug and its weight and diameter, and length of barrel to make use of the expanding air so that it all occurs just before the projectile leaves the bore and the valve is closed, or you're just wasting air. On the other side of that is not enough air, too much residual friction and barrel travel and slower speeds, which I believe is where you are at, since you are doing 38.9fpe to my 45.8fpe with the same shot count. Please post future results, as will I.Heya this will be my second Barra 250z in 22 rifle. First had to RMA due to ar grip hardware being completely separated from the rifle chassis from factory. The replacement came Friday. Saturday I installed the gear - bipod, 4-16x50 monstrum mrad scope and gave her a good cleaning. Today I chronographed and tuned. So far using 25gr Apolo Slugs, here's my current settings and break down.
Current Setup
2,000 PSI Reg
Hammer spring backed out 100%
Hammer Spring set 3.5 Turns In.
1. Power Output
Muzzle Velocity (FPS): ~825-837 FPS
Muzzle Energy (FPE): ~38.1-38.9 FPE
This is a significant increase from the factory default setup (~25 FPE). A gaine of about 13+ FPE at the muzzle, meaning slugs should retain much more energy at 100 yards.
2. Consistency & Spread
Extreme Spread (ES): ~10-14 FPS
Standard Deviation (SD): ~3.5-5.5 FPS
The regulator and hammer setup appear to be working well together. These are very tight numbers, which is good!
FPE at distance
Currently maintaining over 25+ FPE past 30 yards and still carrying 13+ FPE at 100 yards, which target dependant, means lights out.
Estimated shots per fill 30-35 good shots before dropping off a little bit, had 4 mags loaded.
Hijack all the threads! We are all looking for answers. You won't be making anyone upset showing off a 1" group at 100y, as long as you give us every detail. Good luck! ...we're waiting lolI agree - more tuning to come - it's not near what i had the first rifle at - but this was a quick tune to get in the ball park so to speak with the limited sun I had left. Hopefully soon we'll be going out to stretch to that 100yd mark and get some dialed in stats with target history too. To not hijack this thread I'll create a new thread with the data.
Welcome to the forum man! I'm gonna have to break down and get a 250z 25 caliber rifle. Everyone that has one has got it shooting great.Hey guys. Was just wondering what the best tune for the most power is on the Barra 250z. Right now the hammer spring is maxed out and the regulator is set at 2700. Haven't Chronoed it yet.
Welcome to the HAM forum! Getting your 250z dialed in i see. What a great gun that's getting a lot of attention!Heya this will be my second Barra 250z in 22 rifle. First had to RMA due to ar grip hardware being completely separated from the rifle chassis from factory. The replacement came Friday. Saturday I installed the gear - bipod, 4-16x50 monstrum mrad scope and gave her a good cleaning. Today I chronographed and tuned. So far using 25gr Apolo Slugs, here's my current settings and break down.
Current Setup
2,000 PSI Reg
Hammer spring backed out 100%
Hammer Spring set 3.5 Turns In.
1. Power Output
Muzzle Velocity (FPS): ~825-837 FPS
Muzzle Energy (FPE): ~38.1-38.9 FPE
This is a significant increase from the factory default setup (~25 FPE). A gaine of about 13+ FPE at the muzzle, meaning slugs should retain much more energy at 100 yards.
2. Consistency & Spread
Extreme Spread (ES): ~10-14 FPS
Standard Deviation (SD): ~3.5-5.5 FPS
The regulator and hammer setup appear to be working well together. These are very tight numbers, which is good!
FPE at distance
Currently maintaining over 25+ FPE past 30 yards and still carrying 13+ FPE at 100 yards, which target dependant, means lights out.
Estimated shots per fill 30-35 good shots before dropping off a little bit, had 4 mags loaded.
You have choices to make first. Do you want to shoot pellets or slugs? Is power the most important thing, or do you want power with accuracy? What weight ammo are you looking to shoot to get the most power? If you go real heavy you will be shooting real slow with a big parabolic trajectory and will definately need a range finder too. If you go light and fast, flatter shooting but less power. There is no right or wrong answer, it depends what you want to do. You don't need efficiency if you just want to dispatch critters in a trap, but if you want to go squirrel hunting all day and take long shots, you sure will. If you are clear on what you want to do, you will get a clear answer. @Northeastbeast has some products and some videos you might want to check out, he's making big power. To be not wasting your time though, get a chronograph pronto.Hey guys. Was just wondering what the best tune for the most power is on the Barra 250z. Right now the hammer spring is maxed out and the regulator is set at 2700. Haven't Chronoed it yet.
How did you determine the fpe at 30 yards and 100 yards?Heya this will be my second Barra 250z in 22 rifle. First had to RMA due to ar grip hardware being completely separated from the rifle chassis from factory. The replacement came Friday. Saturday I installed the gear - bipod, 4-16x50 monstrum mrad scope and gave her a good cleaning. Today I chronographed and tuned. So far using 25gr Apolo Slugs, here's my current settings and break down.
Current Setup
2,000 PSI Reg
Hammer spring backed out 100%
Hammer Spring set 3.5 Turns In.
1. Power Output
Muzzle Velocity (FPS): ~825-837 FPS
Muzzle Energy (FPE): ~38.1-38.9 FPE
This is a significant increase from the factory default setup (~25 FPE). A gaine of about 13+ FPE at the muzzle, meaning slugs should retain much more energy at 100 yards.
2. Consistency & Spread
Extreme Spread (ES): ~10-14 FPS
Standard Deviation (SD): ~3.5-5.5 FPS
The regulator and hammer setup appear to be working well together. These are very tight numbers, which is good!
FPE at distance
Currently maintaining over 25+ FPE past 30 yards and still carrying 13+ FPE at 100 yards, which target dependant, means lights out.
Estimated shots per fill 30-35 good shots before dropping off a little bit, had 4 mags loaded.
Here is something to try. I have opened up my thimble, so taking that into account, set your reg to 2600 psi, get some Zan 23gr .217 slugs and adjust the hammerspring to get them going at 925fps. This is the best compromise between power, shot count and accuracy to me. This will give about 2 full mags at 44fpe.Hey guys. Was just wondering what the best tune for the most power is on the Barra 250z. Right now the hammer spring is maxed out and the regulator is set at 2700. Haven't Chronoed it yet.
We use essential cookies to make this site work, and optional cookies to enhance your experience.