Morning y'all
I have a question regarding the regulator adjustment on my EPIC 2 walnut classic. As shown in the attached photo illustrating the adjustment point, it is not accessible with the stock installed.
Is this normal, or are there methods to allow the regulator to be adjusted while the gun remains mounted in the stock?
The air tank assembly (Plenum, Regulator housing, Air tank) are all hand tightened, and fully screwed together until each component bottoms out against each other and then to the main block.
Thank you for any insights.
I have also sent an email to the seller and the manufacturer.
I have a question regarding the regulator adjustment on my EPIC 2 walnut classic. As shown in the attached photo illustrating the adjustment point, it is not accessible with the stock installed.
Is this normal, or are there methods to allow the regulator to be adjusted while the gun remains mounted in the stock?
The air tank assembly (Plenum, Regulator housing, Air tank) are all hand tightened, and fully screwed together until each component bottoms out against each other and then to the main block.
Thank you for any insights.
I have also sent an email to the seller and the manufacturer.
