Search results

Umarex is sending me some screws :)

I think sometimes I spend more time tinkering than shooting Was wondering what scope is that and do you like it?

Just found out why my compressor was only reaching about 2000 psi. My cheap air filter leaks.

Found the problem. The cheap blue Amazon filter was leaking. I couldn't hear it over the compressor noise I just happen to grab it to move it over and felt the air leaking. Removed the filter and pumps up fine. Now to find a better filter that I can afford .

So I dug into my Zelos today to check and adjust the pushing pin depth. However, taking the top plate off I found loose screws and one stripped. Even the screw that holds the accuating rod for the push pin was about to fall out. This is all on top of the four missing buttstock screws. Got an...

Tore into my Zelos again to adjust the pushing pin In a little farther.

I normally tear a gun almost completely apart checking everything, cleaning lubing. I just wanted to shoot this straight out of the box. However, I did clean the bore very well first.

First time opening up my Zelos for trigger adjustments. Got the trigger to a crispy #2 Long first stage, but that's the way I like it. Almost no overtravel. Adjusted trigger shoe down a bit to fit my grip better. Very happy. Also drilled the buttstock to access the hammer screw, so I can...

Thanks guys. What about an extended bolt probe? I seem to remember they may add about 40fps

Right now I'm getting 948 fps with 18.1gr JTS pellets but only 847 fps with 23gr H&N Slugs. I'd like to get those slugs to 900 fps. Is this doable without losing accuracy? And best way to achieve this? Thanks

Did the survey, but I wish there was more of a fill in the blank.

Short range session. Shot a couple Pinty Knightfalls. One did well, the other not so much. Then broke out the Zelos .22 First time shooting these pellets a friend gave me. I am going to have to order more. This rifle makes me smile 😊 .

So I have a few knockoff Airforce rifles. The bolt has orings inside that slide over the barrel. Silicone oil is not a good lube for this. Put it on, work the bolt a couple times and the Silicone oil is doing nothing. Even getting it on my fingers, rub them together and it's gone. What else...

Well, I was going to order the Huben gauges, but shipping is over double the cost of two gauges. I'll have to look elsewhere

Kevin at Pinty took care of me ! All is right with the world 🌎 Happy camper.

Tried again today, no joy. Looks like I will tear down the regulator. Also going to pull the the hammer, check for burrs/rough spots and polish. Anything else I should check?

Thank you, To be honest, I have never done a deadhead check on this unit. However, I just topped off two of my guns to 3600 psi with no issues. I did this in the house where it is cool. Temps here are 100*, so I'm guessing my garage is a bit hotter where the pump stopped pumping. So for the...

This is what I was thinking about

I do not like gauges in bar, I like psi. Where to order good gauges in psi from? These would be for my Pinty's which have Cricket regulators. Thanks

Bought new 7/25/2025 off Amazon. Very little use. Was filling one of my air rifles up Took it to about 2000 psi From empty this took about 7 minutes. Then shut it down for zbout 20 minutes while I went in the house. Then decided to go ahead and top it off to 3600 But I had the pump stop set at...