Two questions that probably don't justify a separate discussion for @American Air Arms:
What does the "E-100-1010-31" code signify on the label? Sorry, this is how my brain works.
Where can I find a manual for my pre-owned EVOL 30? Hopefully the answer isn't, if you have to ask you shouldn't...
Mine is set to around 2,100 as well and shooting Hades at 860. I believe there's a "velocity adjuster" on the back. Wondering if that needs a 1/8 of a turn or so.
Those off to the left are from Ghost 22 shooting 23 grain Patriot slugs. Slugs are so sporadic in it.
I've ordered a variety of 30's to experiment with from JTS, JSB, FX and Zan.
These are results from today of the first outing with the new-to-me EVOL 30. Bench setup was not great as my bipod has not arrived. Hades pellets at 50 yards running 860 FPS. Velocity started dropping on shots 46-47 and excluded from data.
I've been lingering here for a few months and couldn't pass this EVOL 30 beauty up from @c.wallace_06.
Scope is mounted and needs dialed in. It's not far off though. Impressive how light this rifle feels and how well it shoulders. It's definitely the longest in my collection.
Also, special...
I'm picking up a new to me EVOL 30 next week and have very few hex tools.
Will these sizes cover me? - Set Includes: .028, .035, .050, 1/16, 5/64, 3/32, 7/64, 1/8
Thank you for the advice.
It came tuned at 960 FPS from AoA tuned with MRDs. Accuracy was superb. That's too much for my home range at 35 yards.
The 900 FPS is shooting one ragged hole. I'm still becoming familiar with my trigger mod and it could probably be better.
I took the plunge and cut the spring to 26mm in length. The side cutters would not allow me to grasp it. Against @Franklink's advice, I lightly heated the brass piece. It took less than 3 seconds of heat and easily spun off. I did measure the distance between the block and edge of the brass...
Yep. Loosening that screw allows the trigger to slide back and forth on a rail. You can actually remove it all together. Screw "F" is tucked back in the cavity. A screwdriver handle hex driver makes it super easy to access.
I haven't cut the spring yet but everything else has been very simple...