If your car had the springs flexed to almost bottomed every time you went over a bump you'd be replacing those springs a lot. I've already replaced the springs on my water trailer twice and they're not worked near as much as the spring in a springer.
This is a experiment that was done by a GTA member from GTA preformed over time.
Keeping a Springer Cocked
By Ken Pangh
OBJECTIVE:To determine the effect on a mainspring if airgun is left cocked for an extended period.
Preparation: Airgun was disassembled, thoroughly...
I just removed the tube from the scba firemen valve. Turn it up side down and crack the valve open just slightly. Any moisture in the tank will be blown out. Of course you need to let the tank sit for a few hours with the valve down to make sure any moisture has collected near the valve. The...
Recently, Snowpeak has discovered unauthorized third parties are selling our branded products online through #www.snowpeakairguns.com# and other similar counterfeit websites. Such acts seriously infringe upon our company’s intellectual property rights and legitimate brand interests, and are...
My liberty .22 is putting out 49 for and that's turned down a little. My impact puts out 56 fpe with my cast 30 grain BBT NOE slugs. It can put out more but why. I know the .22 Sumatra can do over 45 fpe.
One thing readers need to know is that the numbers you stated in the article are relative humility. It's the percent of moisture in the air relative to the temperature and barametec pressure. Cold air typically can't hold as much moisture as warmer air. So the 75% RH in the morning may contain...
Received the spotting scope I bought from GovX. It's a athlon talos and through GovX I got it for half off. I got lucky and our friend who works at the PO kept it from being sent back. I didn't know that GovX was going to send it out usps. I thought it was going to be shipped UPS or FedEx...