Recent content by Jay308

What about the .257?

If it was PB sure, airgun ok…

JSB refuses to accept they have a issue with quality control and this is their downfall. The name only carries you so far, I thought they would fix the issue a year or so after covid. There will always be another company to deliver the product consumers want, if there is a profit to be made.

I have the barrel clamp tensioner block but it seems you have to remove the reg knob to install it. Do I have to degas to remove/install? Does it come out easy or does it have thread locker?

There is a rotating picture on the front page of AoA that looks just like mine with the stock bottle, barrel almost touching. Anyway the Alsafe bottles(Tuxing)are smaller diameter(2.4?)but longer vs the Inocom bigger diameter(2.5?)but shorter. I should have just bought the Tuxing and installed...

The oring didn’t work but it does have less tension on the bottle now. I think my barrel has a slight bow in it and this is the cause. It also had the correct 90 duro in it. I‘m going to get the barrel clamp tensioner, I can push up with my finger under the pic-railed block and it makes...

This is not permeant but is working for now, without it I can hear the shot resonate on the bottle. It groups great like before but not sure if the poi will change when I fill the bottle again. I used a 3/4” plumbing oring over the shroud. I still waiting on the orings to ship, so I can figure...

Obviously not for the HO Vortek spring in my case.

I used a TBT guide kit (old white version) in my TX with the stock spring and Vortek seal, I lost about 40 fps with that seal and it never came back up. It would shoot the 10.3 at 13 fpe. I had a lot of plastic flakes all over inside, so I removed the TbT guides and installed a Vortek full...

I ordered some 14.5 x 3 orings in 90 duro for the barrel oring in the frame, but they are back ordered about 2 weeks.☹️ The BRK sheet said it was a 90 duro, but I’ve read it felt like 70 when removed, so maybe this will help. AoA said it doesn’t matter if the shroud touches the bottle, but I...

The STO is really light and doesn’t change the clearance any. I’ll give the oring a go.

My Ghost has always had very minimal clearance as seen below. I have put on a Omega(inocom)700cc and it touches at the end. I thinking of trying to replace the barrel o-ring in the frame with a 90 duro, this might make the barrel not droop as much? Does anyone know what size this o-ring...

Looking nice!

Best I’ve found so far:

I just contacted AoA and asked to get on a list for the SubMoa barrel again, they said it would be a long wait, Sept/Oct. I was told June/July four months ago. No list to get on, so it might really be a long, long while. Funny how there are Black Wolf barrels but not Ghost barrels as there are...