Recent content by HDODT

Yup. That is where mine broke also. I'm roughly 400 shots in on the new one. I hope it keeps holding up.

Oh no! Send them a message. They may have some saved for warranty. They were good to work with when I emailed them. Good luck.

Thank you for the info. I'll look into them.

I agree. I think I just got a bad sear and due to the lack of information about others having similar issues I have resolved it to just being bad luck. Barra was great to work with in getting a new sear sent under warranty. I'm just glad to be shooting it and can't wait to really get it dialed in.

Chucks and squirrel are on my list for sure.

Got out to shoot it today. I'm super happy with the way it performed. I set up a target at 30 yards and got it zeroed, then started to adjust the the regulator. Brought it up till the JST Dead Center 25.39gr pellets were running about 910fps (2100 on the reg gauge). I'm really happy with the SDs...

The creep is very minimal I could adjust it out but then the trigger is super light. Way lighter than I like. I'll keep tinkering with it once I start shooting it.

Yeah, it showed up yesterday. I got it installed and it seems to work great. I didn't have time to charge it up and shoot it yet though. Maybe today. I did the single stage trigger conversion with the rouge air spring and have that feeling pretty good. It's really light with just a little...

I meant switch/button not bar. I'm thinking I'll just leave the safety out and use other methods to keep it in a safe state until I'm ready to shoot.

I was thinking it wouldn't be hard to fab one up out of better material. It looks like centered metal is what they use for it and with that spring pocket being so deep it's gotta be really weak right there.

I hadn't thought of decocking with one in the chamber. I'll for sure use that. I'll just have to be careful to not double feed I guess. The sear will be here Friday. I can't wait.

It looks like I can get a safety bar from Barra. I'll probably order one just to have the ability to put it all back to stock if I do go that route. I come from shooting powder burners, long range precision type stuff. The safeties on those rifles never gets used. The bolt is always open until...

Thank you.

I'm thinking that with the lack of others having the same problem it's just a bad luck deal and will be great once I get a new sear. Barra got back to me and sent a new sear under warranty. I'm really looking forward to shooting it. I've got 6 different slugs and pellets to test out in it.

Thank you for the detailed explanation. I'm guessing this is completely reversible if it doesn't work out?