Search results

Does anyone know for a fact that the thumper comes with or without a notch in the barrel for the shroud? If I know this, I know if there is in fact, a problem with the gun or if it is just the shroud notch.

I all ready made a notch in a different spot than where it was from the factory. The problem still remains. All that we have talked about so far I have tried already and have no cure yet.

Now that I think of it, there may have been a notch in the barrel for the set screw. When I took the shroud off the first time, there was nothing but a groove from where that set screw dug in sliding forward.

I tried turning the hammer spring down as far as I could but it still happens.

Dremel tool.

I believe that it is caused by the pressure of shooting. I have no clue as to why and how. It does affect accuracy.

I have had the shroud off and there was not a recess. I made a slight one but didn’t want to go too deep because it is the barrel.

I have a Pinty thumper that no matter what I do the barrel shroud keeps pulling away from the block. I have tried everything along with Loctite on the set screw, and it still keeps sliding forward. It slides forward so much as the set screw leaves grooves in the barrel. Any solutions or remedies?