Depending on the humidity in your area you should consider using silica gel bear cannisters on your compressor inlet. I use two 1/2 liter gel bead cannisters in series on the inlet and I am in the AZ desert. I get very little moisture in the filter of high pressure air going to my SCBA tank...
These high pressures are dangerous. I have become accustomed to 4500 psi but I only fill my SCBA tanks which are rated at 4500 to 3500 psi. None of my pcps shoot at over 2900 psi anyway. It also takes longer to go from 3500 to 4500 than it does to go from empty to 3500 psi.
I use my Yong Heng to fill 4 large SCBA air tanks to 3500psi. I fill one five gallon bucket half full of water and add 1/2 gallon jugs of ice to the bucket and replace the jugs with other frozen jugs as the ice melts. Not very hard to do and a very economical way to fill high pressure tanks to...
Getting rid of some of the invasive birds, starlings, english sparrows, and eurasian doves allow more of our native birds to reestablish their habitats. Good job in helping the natives out.
I started by borrowing a friend's NP trail break barrel in .177. I bought a Crosman Nitro Venom Dusk in .177 and used it until the nitro piston failed. 9 years later I have 25 airguns mostly PCP and .22 and .25 for shooting in windy conditions. The .177 get moved around too much at 60 yards.
One potential problem not mentioned yet is leaving the airgun with a pressure charge of CO2 for any length of time.
This is not recommended for any CO2 airgun. You can leave the nitrogen cylinder attached to the Komplete for a long time as shown in the review by HAM.