Went out to try a coyote stand or two this evening. Was headed a few miles back behind our place so I took the 'buggy'.
I came SOOOO close to getting my first air rifle coyote of this Fall! I was setup in semi-open pines. I could see some openings to about 70yds but most ground all around me...
On the bench with the Uragan 2 and the 250z this morning. Cold this morning but little wind.
Fired 45-rounds through the 250z. Had two 5-shot groups that were both smaller than the group I showed on here yesterday! :cool: Couldn't really get photos of those as they were on a re-used...
Fired eight, 5-shot groups through the 250z this morning. I 'cherry picked' a group that I thought was worthy of sharing on here. Average 5-shot, 50yd groups are normally about half-again this size from my 250z.
Hope you enjoy my 250z efforts. :)
Pumacarl & Billm, keep in mind that the G3s assisted valve is not going to respond to spring and hammer changes the same way a conventional valve will.
On the Uragan 2 the balanced/assisted valve showed almost no change at all with spring adjustments. In fact, it says right in the U2 manual...
Billm, how did you get your single shot tray to work considering the breech seal o-ring is on the probe and not in the breech? I mean, does the 'ditch' for the pellet to lay in match the O.D. of the o-ring, or does it match the entrance into the breech?
I've been studying Pumacarl's G3 trigger group pics (thanks PC) trying to decide how I would go about adjusting/modifying the trigger group to make a nice, light, crisp single-stage trigger if I was to buy a G3. PCs pics show clearly how all the parts of the trigger group interact, except one...
I think PC said it well in his post above. When slugs work, they really work! But it's a fact that not all air rifles will shoot slugs..., regardless how many a person tries.
Expect a large investment for that endeavour! Unless you get lucky and hit on a slug that works right off the bat..., you'll wind up with a large investment in partially used slug containers! :unsure:
I thought about you many times the last few days as I watched the news. Not knowing where you lived, I hoped you were not in danger. Glad you made it through!
Bud's doesn't have free shipping so ya have to figure that in the cost. I took the order process out far enough to see shipping cost and it was only about $14.
Buying direct from Benjamin is the current (10/7/26} best deal with their Fall Promo price.
Same airgun routine for me today. Fired 3-shots through my Uragan2 .25 and 50-shots through my 250z .22.
Went out again yesterday trying to call a coyote during the last 2hrs of daylight but no luck. I'll have better luck when I drive a short distance east from home into desert habitat. I'll...
Benjamin has the best price on the Gen3 at the moment (10/7/26). They have a Fall Promo that is 10% off and free shipping. Best price I've seen in the last few weeks. I'm so tempted! :unsure:
https://www.benjaminairguns.com/
Went out his evening and made a coyote calling stand. Waited until it was late enough to just sit on one stand. Was going out last Friday but plans changed so this was my first attempt for this Fall/Winter.
No luck, unless I wanted to see Ravens and Mountain Jays! There were lot's of birds...
Fired my U2 and my 250z this morning. U2 got a bore cleaning yesterday so took about 20-shots of expensive Altaros slugs to get the rifle back to grouping! :(
Noticed my compressor seemed a little slow filling the last couple days. This morning while filling the 250z the compressor wouldn't...