Search results

Did you slug your barrel?

How did you remove the carbon fiber ?

You can't make me talk!!! OK, a Skout .22 barrel for my 250Z

Eating utensils handels....Could work..

Utah free shipping weekend..

Use a tiny amount of grinding compound in the scope grooves of the receiver .. Then mount you scope rings on top of the compound..

Just balancing with the hammer spring and pressure.. The external reg is inline between the tank and the rifle..I usually set it about 80% of the rifles max pressure.. Most run the best around there,,

Like this.... I put in the slug weight wrong..

Oh It can be lower, in the single digit.. I have a external regulator, so I tune to the most power and the find a slug it like and lower it with the hammer spring from there to find the tightest group...

The 250 will be just fine for me with a external plenum.. I will stay with it... 20.83 gr Weather: 53.9°F 7.0mph scattered clouds 991hPa/mbar 29.26inHg 46% Shot count: 27 Low: 1014 Hi: 1042Avg: 1029 STD Dev: 7 Spread: 28 11/12/25 1:00:49 PM,1030,FPS,49.1,FT Lbs,11/12/25 1:01:07...

That looks like they were that way before they were packed ! email them and they should make it right...

Size ? Of the plastic (delrin?) seal

Only the center screw..

Tension screw as backed out till the hammer spring is lightly compressed.. Then tune as you have stated...

Test with the stock off .. When you get it set then put the stock on...

O ring chart on the post that I put up...Just click on it and it will enlarge..

I would replace it with a stainless steel hex...

8x1 should be it

It should start out somewhat tight and then It should be the same all the way through..

I believe it has the o ring on or in the intake sleeve or thimble,, #17 5.5x1.5 #18 10x1.5.