Recent content by pepper51

Been considering a DRS for some time now. So yesterday I preordered a DRS MKII in .22 cal, 500mm length barrel in the synthetic stock from Utah Airguns. I say preordered because they are out of stock and they expect delivery in a few weeks. I got the synthetic stock because of being ambidextrous...

If I were to buy the new FX DRS MK2 with 500mm bbl, are there any modifications or FX accessories that should be considered? Since I am left handed, I would buy the synthetic model because I prefer traditional look and feel. Still be using the FX 18.1 pellet for field and target. By the way...

Wow, a mountain of information. Sure to make my head spin. Thank you for all this.

Matthias, Group B, 10y parallax. You have my attention. Thanks, Ralph

Thanks for the effort. I did spend considerable time looking here before asking.

Okay, getting a bit lacking in memory, but I think I read where some company is or has come out with an air gun scope that has a less cluttered reticle. I meant to make a note of that article but must have failed to do so. Think I read it here on Hard Air Magazine. Thanks.

500mm or 600mm. likely 600mm.

FX DRS Classic in .22 has been tugging at me for a while. What has been your experience with the DRS? I am interested in staying with the 18.1 grain pellet or 15.89. These both have worked well in other rifles for field and target. I presently have an Air Arms S500 and Daystate LH Regal in .22...

Many thanks for all the replies. It always helps when someone has experience.

I recently bought a used AA S500 in .22. Nice little rifle but loud. What moderator are you using or would recommend for the S500? Thanks.

This is an interesting thread. I hope it keeps going. Why did I buy a Wolverine R? I was looking for a left-hand stock in .22 and the Wolverine is ambidextrous. Not into electronics so looking for mechanical. AoA had the one I bought just a few months old in like new condition with all at a...

I ordered the single shot loader from Rowan and it arrived today. Very happy with ordering from them.

I thought about the ring swap but have not tried it. I will take your suggestion NOT to try and bounce the gun and scope off the concrete floor.

I think I may be in need of adjustable scope mounts to be used on a Daystate Wolverine R. With optics centered on a Aztec Emerald 5.5-25x50 scope, pellet impact is low just shooting inside my shop at 20 feet for initial sight in. Low enough to near max out elevation to get to be where it needs...

Thanks so much for your reply's. I will place my order.