Crown The Hater Creator/Fx Crown MK2

Northeastbeast

Well-known member
166
286
Usa
HAM Points
789.75
Country flag
This rifle has been outstanding in all aspects. Its a Crown mk2 GRS gray wolf set up with kelbly matched benchrest scope rings & a Sightron S3 fixed 45x ED scope. 600mm barrel with standard liner. Tuned for 25 grain Jsb monster redesign pellets at 965 fps. This rifle helped me finish 4th in the nation in 2022 in N50 with a dozon 1st place finishs. Best card being a 250 15x. The only rifles above me were 3 Well tuned Thomas rifles. I named it the Hater Creator for obvious reasons 😉. The rest is a Randolph Precision rifle rest with custom speed wheel. Amazing rest which i Acquired from 25 meter world champion Todd Banks. I spent many hours tuning this rifle and when i got it right...I GOT IT RIGHT. I stepped away from N50 pellet class in 2023 to allow our youngest son to shot the rifle in N50 pellet class "He did great" well i moved over to slug/rimfire class where i used my Fx Panthera. I did really well locally but could not hang nationally with the rimfire guys who print 250 20x 22x 21x regularly. My best card in slug was a 248 14x nothing to shake a stick at but not good enough. Still have alot to learn when it comes to shooting slugs in benchrest. The Hater Creator now belongs to our youngest son and i am moving to something else. That something else has yet to be determined. I have a few contenders but nothing set in stone. If you dont shoot N50 you should alot of fun alot of clubs nation wide and great competition.
 

Attachments

  • Screenshot_20240109_162107_Instagram.jpg
    Screenshot_20240109_162107_Instagram.jpg
    782.3 KB · Views: 17
Mind my asking a few questions about your tune on the Hater Creator for the MRD?

What is your reg pressure set at?
What is your hammer power wheel setting?
Approximately where have you got the hammer micro adjustment set at?
Are you using the stock hammer and hammer spring?

Thanks!

P.S. If this is proprietary information, understood :)
 
Mind my asking a few questions about your tune on the Hater Creator for the MRD?

What is your reg pressure set at?
What is your hammer power wheel setting?
Approximately where have you got the hammer micro adjustment set at?
Are you using the stock hammer and hammer spring?

Thanks!

P.S. If this is proprietary information, understood :)
I would have to pull the rifle out to give you the gritty details. But stock spring no hammer weight. Wheel is at max and reg is at 150 bar
 

Create an account or login to comment

You must be a member in order to leave a comment

Create FREE account

Create a FREE account on our community. It's easy!

Log in

Already have an account? Log in here.

Back
Top