Woogie_man
HAM Wizard
- Original poster
- #61
Ok now I am on my computer and I can type stuff out now.
Those groups are all 10 shots from the magazine. The only round that I had issues with was the 38 grain Hollow Ogive slugs. They were hanging on the magazine and wouldn't allow the carriage to spin. I am going to measure the overall length and compare them to the others. If I need I can put them back into the press and close them up a bit more and try again.
I am wanting to stay around the 150-160 BAR mark on the regulator, as I don't want to stress the system to much. So I am happy to see the 40 grain slugs moving fast enough on the lower settings. And the standard deviations are quite low as well. Though I do think the rifle would be able to get them down lower.
I do think that the barrel is showing promise FINALLY! I ended up removing the tensioner and putting back on the original shroud. Did testing with just the shroud and then tested with the Impulse Air 1350.
Those groups are all 10 shots from the magazine. The only round that I had issues with was the 38 grain Hollow Ogive slugs. They were hanging on the magazine and wouldn't allow the carriage to spin. I am going to measure the overall length and compare them to the others. If I need I can put them back into the press and close them up a bit more and try again.
I am wanting to stay around the 150-160 BAR mark on the regulator, as I don't want to stress the system to much. So I am happy to see the 40 grain slugs moving fast enough on the lower settings. And the standard deviations are quite low as well. Though I do think the rifle would be able to get them down lower.
I do think that the barrel is showing promise FINALLY! I ended up removing the tensioner and putting back on the original shroud. Did testing with just the shroud and then tested with the Impulse Air 1350.




